Removing The Vrm; Replacing The Vrm - Dell Precision 330 Service Manual

Back to Contents Page
VRM
Dell Precision™ WorkStation 330 Systems Service Manual
Overview
Removing the VRM
Replacing the VRM
Overview
The voltage regulator module (VRM) senses the microprocessor's voltage requirements and ensures that the correct voltage is maintained.

Removing the VRM

CAUTION: Before you perform this procedure, see
NOTICE: Before disconnecting a peripheral from the system or removing a component from the system board, verify that the standby power indicator on the
system board has turned off. To locate this indicator, see
1. Turn off the computer and peripherals, disconnect them from their electrical outlets, wait at least 5 seconds, and then
2. Rotate the power supply away from the system board.
3. Remove the VRM securing clip:
a. Press down on the two raised points of the clip's top surface to release it from the VRM connector.
b. Lift the clip away from the VRM (see the following figure).
Removing the VRM
4. Grasp the VRM by its top corners, and ease it out of its connector.

Replacing the VRM

1. Align the slot on the bottom of the new VRM with the ridge inside the connector.
2. Press the VRM straight into the connector.
3. Replace the VRM securing clip:
"Precautionary Measures."
"System Board Components" or "Interior Service Label."
remove the computer cover.