Dell Precision 330 Service Manual page 76

76 Disk Dri ves and Media
Reinstall the hard-drive bracket in the chassis (see the following
3
figure).
Insert the bracket into the chassis by inserting the hooks in the slots on
the front of the chassis. Then lower the bracket to the bottom of the
chassis, making sure that the latch on the externally accessible drive
bay is engaged. Replace the screw holding the drive bracket to the
drive bay.
I n s t a l l i n g t h e H a r d - D r i v e B r a c k e t ( D e s k t o p C h a s s i s )
Connect the interface cable for the drive. See
4
Cables (Desktop Chassis)."
NOTICE: To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
If you are installing an EIDE device, ensure that the IDE interface
a
cable is properly connected to the EIDE connector on the system
board.
screw
latch
hooks (3)
hard-drive bracket
"Attaching Hard-Drive