88
Disk Dri ves and Media
NOTICE:
Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see
Components" or
"Interior Service
Turn off the computer and peripherals, disconnect them from their
1
electrical outlets, wait at least 5 seconds, and then
computer
cover.
Rotate the power supply
2
Remove the front
panel.
3
Disconnect the DC power and interface cables from the back of the
4
drive.
Remove the drive bracket from the chassis.
5
Pull the drive door forward and down until the hard-drive bracket is
ejected halfway out of the chassis (see the following figure). Then
grasp the bracket and pull it completely out of the chassis.
Label."
away from the system board.
"System Board
remove the