Dell Precision 330 Service Manual page 152

152 Mic r op r o c es s o r
NOTICE: If you are not installing a microprocessor upgrade kit from Dell,
reuse the original heat sink and securing clips when replacing the
microprocessor. There should be enough thermal grease remaining on the
bottom of the het sink to provide adequate thermal conductivity from the
microprocessor.
Lower the heat sink to the microprocessor so that the heat sink fits
a
in the heat sink retention base.
For each of the replacement metal clips that secure the heat sink
b
to the microprocessor, fit the end of the clip that does not have the
latch to the heat sink retention base. Then, press down on the
clip's latch to secure the clip to the heat sink retention base (see
"Removing the Microprocessor Heat
Replace the airflow shroud.
3
Rotate the power supply back into position until the securing tab
4
snaps into the release latch.
Replace the computer cover and
5
Enter system setup, and confirm that the top line in the System Data
6
area correctly identifies the new microprocessor. Also, confirm that the
values under the CPU Information menu are correct for the new
microprocessor.
Exit system setup, and then run the Dell Diagnostics to verify that the
7
new microprocessor is operating properly.
Sink").
restart the system.