Table of Contents
Advertisement
Replacing the stability foot
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
Procedure
1. Tilt the computer towards the front until the base is facing up.
2. Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws
(#6-32x6).
3. Tilt the computer back to the upright position.
computer. After working inside your computer, follow the instructions in
After working inside your
21
Advertisement
Table of Contents
