Table of Contents
Advertisement
VIVOTEK
disablemdonptz
7.41 camera PTZ control (IZ series)
Group: camctrl_c<0~(n-1)> for n channel products
capability_camctrl_c0_buildinpt = 0)
n denotes the value of "capability_nvideoin" and k denotes the value of "capability_npreset"
NAME
ccdtype
motortype
cameraid
panspeed
tiltspeed
zoomspeed
autospeed
focusspeed
focusmode
uart
isptz
322 - User's Manual
<boolean>
1/4
VALUE
string[16]
string[16]
0 ~ 255
-5 ~ 5
-5 ~ 5
-5 ~ 5
-5 ~ 5
-5 ~ 5
auto,onetimeauto,spotligh
t,manual
* Available values are
listed in
"capability_camctrl_c<0~
(n-1)>_focusmode"
0 ~ "capability_nuart"-1
0 ~ 2
2: enable PTZ commands with UART tunnel.
* Only available when bit7 of
capability_ptzenabled is 1
Disable motion detection on PTZ operation.
(capability_camctrl_c0_zoommodule = 1 and
SECURITY
DESCRIPTION
(get/set)
6/7
(Internal used, read only)
6/7
(Internal used, read only)
1/4
Camera ID controlling external PTZ
camera.
Note:
Please set your speed dome to the
appropriate baud rate, and Camera ID,
e.g. 2400bps, camera ID 1,2,3,,,,etc.
All Camera IDs on the same controlling
system (NVR or rs485 keyboard) have
to be distinct.
Therefore, once you send a controlling
signal, each camera will only accept the
inputs with the corresponding ID.
1/4
Pan speed
1/4
Tilt speed
1/4
Zoom speed
1/4
Auto pan speed
1/4
Auto focus speed
1/4
Indicate the focus control mode.
1/4
Select corresponding uart
(capability.nuart>0).
1/4
0: disable PTZ commands.
Advertisement
Table of Contents
