Table of Contents
Advertisement
VIVOTEK
There are three types of rules:
Single: This rule allows the user to add an IP address to the Allowed/Denied list.
For example:
192.168.2.1
Network: This rule allows the user to assign a network address and corresponding subnet mask to
the Allow/Deny List. The address and network mask are written in CIDR format.
For example:
IP address range 192.168.2.x will be bolcked.
If IPv6 filter is preferred, you will be prompted by the following window. Enter the IPv6 address and
the two-digit prefix length to specify the range of IP addresses in your configuration.
Range: This rule allows the user to assign a range of IP addresses to the Allow/Deny List.
Note: This rule only applies to IPv4 addresses.
For example:
Administrator IP address
Always allow the IP address to access this device: You can check this item and add the
Administrator's IP address in this field to make sure the Administrator can always connect to the
device.
User's Manual - 121
Advertisement
Table of Contents
