Configure A Basic Or Extended Ipv4 Acl - NETGEAR GS418TPP User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
The default password is password.
The System Information page displays.
5. Select Security > ACL > Basic > MAC Binding Table.
6. To delete a MAC ACL-to-interface binding, do the following:
a. Select the check box next to the interface.
b. Click the Delete button.
The binding is removed.
The following table describes the information that is displayed in the MAC binding table.
Table 85. MAC Binding Table
Field
Interface
Direction
ACL Type
ACL ID
Sequence Number

Configure a basic or extended IPv4 ACL

An IPv4 ACL consists of a set of rules that are matched sequentially against a packet. When
a packet meets the match criteria of a rule, the specified rule action (Permit or Deny) is taken,
and the additional rules are not checked for a match. You must specify the interfaces to
which an IPv4 ACL applies, as well as whether it applies to inbound or outbound traffic.
Multiple steps are involved in defining an IPv4 ACL and applying it to the switch:
1. Add an IPv4 ACL ID (see Add an IPv4 ACL on page 362).
The differences between a basic IPv4 ACL and an extended IPv4 ACL are as follows:
• Numbered ACL from 1 to 99. Creates a basic IPv4 ACL, which allows you to permit
or deny traffic from a source IP address.
• Numbered ACL from 100 to 199. Creates an extended IPv4 ACL, which allows you
to permit or deny specific types of Layer 3 or Layer 4 traffic from a source IP address
Manage Device Security
Description
The interface of the ACL assigned.
The selected packet filtering direction for the ACL.
The type of ACL assigned to the selected interface and direction.
The ACL name identifying the ACL assigned to the selected interface
and direction.
The sequence number signifying the order of the specified ACL relative
to other ACLs assigned to the selected interface and direction.
361 User Manual