NETGEAR GS418TPP User Manual page 105

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Enable the DHCP L2 relay mode
You can enable the DHCP L2 relay mode.
To enable the DHCP L2 relay mode:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select System> Services > DHCP L2 Relay > DHCP L2 Relay Global Configuration.
6. Select the Enable radio button
The default admin mode is disabled.
7. Click the Apply button.
Your settings are saved.
Configure System Information 105 User Manual