NETGEAR GS418TPP User Manual page 419

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
6. Select an Admin Mode radio button:
• True. Port mirroring is enabled.
• False. Port mirroring is enabled.
7. From the Destination Port menu, select the destination port to which port traffic must be
copied.
You can configure only one destination port on the system. The port functions as a probe
port and receives traffic from all configured source ports. If no port is configured, None is
displayed. The default is None.
8. Click the Apply button.
Your settings are saved.
The following steps must be performed in the Source Interface Configuration section.
9. Use one of the following methods to narrow down the ports that are displayed:
• Select Unit ID to display the physical ports of the selected unit.
• Select LAG to display a list of LAGs only.
• Select CPU to display a list of CPUs only.
• Select All to display a list of all physical ports, LAGs, CPUs, and VLANs.
10. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
Traffic from the selected ports is sent to the probe port.
11. From the Direction menu, specify the direction of the traffic that must be mirrored from the
selected source ports:
None. The value is not configured. This is the default setting.
•
• Tx and Rx. Monitors transmitted and received packets.
• Rx. Monitors received (ingress) packets only.
• Tx. Monitors transmitted (egress) packets only.
12. Click the Apply button.
Your settings are saved.
The Status field indicates the interface status.
Monitor the Switch and the Traffic 419 User Manual