NETGEAR GS418TPP User Manual page 381

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
• Src. In the Src field, enter a source IPv6 address or source IPv6 address range to be
compared to a packet's source IPv6 address as a match criterion for the selected
IPv6 ACL rule:
- If you select the IPv6 Address radio button, enter an IPv6 address or IPv6 range
to apply this criteria. If this field is left empty, it means any.
- If you select the Host radio button, enter a host source IPv6 address to match the
specified IPv6 address. If this field is left empty, it means any.
The source IPv6 address argument must be in the form documented in RFC 2373
where the address is specified in hexadecimal numbers using 16-bit values between
colons.
• Src L4. The options are available only when the protocol is set to TCP or UDP. Use the
source L4 port option to specify relevant matching conditions for L4 port numbers in
the extended ACL rule.
You can select either the Port radio button or the Range radio button:
- If you select the Port radio button, you can either enter the port number yourself
or select one of the following protocols from the menu:
• The source IP TCP port protocols are domain, echo, ftp, ftpdata, www-http,
smtp, telnet, pop2, pop3, and bgp.
• The source IP UDP port protocols are domain, echo, snmp, ntp, rip, time,
who, and tftp.
Each of these values translates into its equivalent port number, which is used as
both the start and end of the port range.
Select Other from the menu to enter a port number. If you select Other from the
menu but leave the field blank, it means any.
The relevant matching conditions for L4 port numbers are as follows:
• Equal. The IPv6 ACL rule matches only if the Layer 4 source port number is
equal to the specified port number or port protocol.
• Less Than. The IPv6 ACL rule matches if the Layer 4 source port number is
less than the specified port number.
• Greater Than. The IPv6 ACL rule matches if the Layer 4 source port number
is greater than the specified port number.
• Not Equal. The IPv6 ACL rule matches only if the Layer 4 source port number
is not equal to the specified port number or port protocol.
- If you select the Range radio button, the IPv6 ACL rule matches only if the
Layer 4 source port number is within the specified port range. The starting port,
ending port, and all ports in between are a part of the Layer 4 port range.
The Start Port and End Port fields identify the first and last ports that are part of
the port range. They values can range from 0 to 65535.
Manage Device Security 381 User Manual