Crestron
TPS-2000L Hookup Details
CAUTION:
Do not remove the tape that covers the photosensor. Doing so can short the
board and damage the touchpanel.
CAUTION:
Do not apply excessive pressure to the touchscreen display during handling
(mounting/installation). Doing so can crack the screen and damage the touchpanel.
Hardware Connections for the TPS-2000L (Back of the Unit is Shown)
The 8-pin connector on the unit provides balanced/unbalanced audio and
video (supporting both NTSC/PAL formats). Refer to the pinout after this
paragraph for details.
The left most columns provide a signal name for each pin. For a balanced
audio/video system refer to the BALANCED AUDIO & VIDEO column centered
in the table. Balanced video format is typically used when distributing video
via CAT 5 (i.e., from a Crestron CNX-PVID8x3 or 8x4).
To obtain unbalanced audio or video, attach jumpers to designated pins and
make connections as described in the three right-most columns. Unbalanced
video format is typically used when distributing video via coaxial cable.
Crestron Quick Guide to Touchpanel Connections
Quick Guide to Touchpanel Connections
Doc. 4903
29