Crestron
NTSC/PAL INPUT
This port provides unbalanced composite and S-video input (using a 2-
position mini-terminal block connectors) or balanced video input (using a 6-
position mini-terminal block connector) for video signals.
Both sets of inputs support both NTSC and PAL formats. Balanced video
format is typically used when distributing video via CAT 5 (i.e., from a
Crestron CNX-PVID8x3 or 8x4). Unbalanced video is typically used when
distributing video via coaxial cable.
C
+ - S + - S
NOTE:
Cable runs for balanced video should not exceed 500 feet (152.4 meters) and cable
runs for unbalanced video should not exceed 100 feet (30.5 meters). For distances greater
than these specified lengths use a distribution amplifier.
NTSC/PAL Balanced Video Input Pinouts
NOTE:
When sending balanced video from a CNX-BIPAD8 or CNX-PVID device, only the
positive (+) and negative (-) wires are to be connected to the touchpanel. Do not connect
the shield (S) wires (pins 3 and 6).
Crestron Quick Guide to Touchpanel Connections
Quick Guide to Touchpanel Connections
NTSC/PAL INPUT
Y
COMP
Y S
C S
PIN #
DESIGNATION
1
2
3
4
5
6
C (+)
Chrominance (Positive)
C (-)
Chrominance (Negative)
C (S)
Chrominance (Shield)
Y (+)
Luminance (Positive)
Y (-)
Luminance (Negative)
Y (S)
Luminance (Shield)
DESCRIPTION
Doc. 4903
43