Net/Video (To Panel) - Crestron TPS-3000 Connection Manual

Crestron

NET/VIDEO (To Panel)

This 10-pin RJ-45 connection mates with the TPS-3000, TPS-5000, or TPS-
6000 touchpanel.
Refer to the descriptions and pinout table that follow
this paragraph. The 10-pin net/video cable assembly
to connect the touchpanel to the TPS-IMPC is
supplied. This port provides the Cresnet connection
to the touchpanel.
This port also provides composite or S-video input
for the built-in video card (with the purchase of a
TPS-3000 or installation of the TPS-VID-1/2 in a
TPS-5000 or TPS-6000 touchpanel).
CAUTION: It is possible to mistakenly insert the 8-pin audio cable into this port.
Consult the latest revision of the TPS-3000 Operations Guide (Doc. 6076) or
TPS-VID-1/2 Operations & Installation Guide (Doc. 6059) for details.
NET/VIDEO Pinouts
PIN
1
2
3
4
5
6
7
8
9
10
To determine the location of pin 1, hold the cable so that the end of the 10-
pin RJ-45 connector is facing away from you, with the clip side down and the
copper side up.
The copper connector on the far left is pin 1.
CAUTION: The 10-pin RJ-45 net/video connector cable supplied by Crestron is a custom
cable and is the only one that should be used. The end of the cable has a metal shield that
is required to protect the equipment. Using non-Crestron cables will result in damage to the
product.
Crestron Quick Guide to Touchpanel Connections
Quick Guide to Touchpanel Connections
DESIGNATION
+24V Power (Network)
GND Ground (Network)
C + Chrominance (Positive) /Composite 2
C - Chrominance (Negative) /Composite 2
Y Data (Network)
Z Data (Network)
Y + Luminance (Positive) /Composite 1
Y - Luminance (Negative) /Composite 1
GND Ground (Network)
+24V Power (Network)
DESCRIPTION
Doc. 4903
37