Usb; Pwr (Power) - Crestron TPS-3000 Connection Manual

Quick Guide to Touchpanel Connections

USB

Two Universal Serial Bus (USB) "A" connectors provide a
communications link to a variety of third-party USB
peripherals. USB connectors are used for touchpanels, storage
devices and keyboards.
•
•
Additional functionality/compatibility will be available in
future firmware releases.
USB is a connectivity specification developed by the USB Implementers
Forum that provides a single, simple, standardized way to connect up to
127 devices to a computer. USB shielded cables contain two wires for power
+5 volts (red) and ground (brown) and a twisted pair of wires (yellow and
blue) that carry data. The USB standard supports data transfer rates of 12
Mbps (megabits per second). USB devices can be connected or
disconnected without restarting the computer.
USB Type A Connector Pinout
NOTE: Only standard Windows
cannot be loaded.
NOTE: The maximum length for a USB cable run is 16.4 feet (5.0 meters)

PWR (Power)

This female connector is used to supply 12 VDC power to the
touchpanel from the included external power pack.
Power Requirements: 101 Watts (8.4 Amp @ 12 VDC) From
supplied power supply.
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to do so
could cause equipment damage or void the Crestron warranty.
Doc. 4903
4
PQI USB 1.1 Compact Flash Reader and Sandisk
ImageMate USB 2.0 Reader/Writer have been tested.
USB mice (Gyration Ultra GT Cordless Optical Mouse,
Belkin, and Logitech USB mice have been tested).
PIN DESCRIPTION
1 +5 VDC
2
3
4 Ground
®
XP embedded drivers are included. Additional drivers
Data -
Data +
Crestron Quick Guide to Touchpanel Connections
Crestron