Net; Usb; Phone - Crestron TPS-3000 Connection Manual

Quick Guide to Touchpanel Connections

NET

The four-pin 5 mm
detachable terminal block
provides communication
with and power from a
Cresnet control network.
Pins 24 and G provide 24
VDC and ground.
Pins Y and Z provide
communications (data).

USB

One Universal Serial Bus (USB) "B"
connector provides a communications link.
USB is a connectivity specification
developed by the USB Implementers
Forum that provides a single, simple,
standardized way to connect devices to a
computer.
USB shielded cables contain two wires for
power +5 volts (red) and ground (brown)
and a twisted pair of wires (yellow and
blue) that carry data.
NOTE: This connector is reserved for future applications.

PHONE

Connect this standard mini phone jack (12 mW, 32 ohm load) to
the plug of a 3.5 mm external headphone set plug (not supplied).
Plugging in the headphone cuts off the speakers.
The headphone output is for WAV and Line audio only. It does not
carry the microphone signal.
Use the AUDIO OUT on the TPMC-CH-IMC for the microphone
signal.
Doc. 4903
14
®
Cresnet Power Usage
Not including TPMC-CH-IMC (1.0W)
TPS-12 = 43 W (1.8 A @ 24 V)
TPS-15 = 65 W (2.7 A @ 24 V)
TPS-17 = 74 W (3.08 A @ 24 V)
Crestron recommends an
independent power supply for
these touchpanels.
USB Pinouts
PIN
1
2
3
4
Crestron Quick Guide to Touchpanel Connections
Crestron
DESCRIPTION
+5 VDC
Data -
Data +
Ground