Kurzweil PC4 SE Musician's Manual page 83

Split and Layer Parameters
The following parameters are available for each of the 5 Zones.
On the Split and Layer pages, the left hand Zone column indicates the Zone number
associated with each of the 5 rows of parameters.
Status
Use the Status column to set each Zone to Active or Muted.
Zone Status can also be controlled by using the front panel 1-5 buttons in the CONTROL
section. While creating a Split or Layer, Zones 3-5 can be turned On by turning on the front
panel 3-5 buttons in the CONTROL section. By default the keyrange of Zones 3-5 cover the
whole keyboard range, allowing these Zones to be used as additional layers.
Program
The default Split or Layer Program will appear in Zone 2. Use the ALPHA WHEEL or
CATEGORY buttons to select a different Program for Zone 2.
LoKey / HiKey
The LoKey and HiKey parameters set the keyboard ranges for each Zone. Using Split sets the
boundary between Zone 1 and Zone 2 to E3. Using Layer sets the Zone 2 keyboard range
to C1 - G9. Change these parameters for each Zone to create custom Split and Layer key
ranges.
Values for the currently selected Key Low or Key High parameter can be selected by holding
down the ENTER button and then playing the desired key on the keyboard. Values can
also be selected by using the ALPHA WHEEL, or by using the keypad function of the
CATEGORY buttons, followed by pressing the ENTER button.
Pan
The Pan parameter sets the panning (left/right stereo placement) of each Zone. To change the
panning of a Zone:
1. Select a Pan parameter for the desired Zone by using the NAVIGATION buttons.
2. Change the panning by using the ALPHA WHEEL, or use the keypad function of the
CATEGORY buttons to type a pan value (0-127) followed by pressing the ENTER
button.
Multi Mode
SPLIT and LAYER Buttons
4-9