Kurzweil PC4 SE Musician's Manual page 10

8. If you are using speakers, turn the master volume all the way down on your amplifier
or mixer. Using standard (1/4-inch) audio cables, first plug into the input jacks of your
amplifier or mixer, then plug the other end of the cables into the PC4 SE AUDIO OUT
jacks. (Connecting in this order minimizes the possibility of static discharge damage.) For
a mono signal, only use the LEFT (MONO) jack, and leave the RIGHT jack unplugged.
Balanced ("TRS" or "Stereo") cables are recommended if your mixer or amp supports
balanced inputs.
9. If you are using headphones, connect stereo headphones to the headphone jack on the
rear panel.
10. Move the PC4 SE VOLUME Slider all the way down.
Powering On the PC4 SE
1. Power on the PC4 SE by pressing the POWER button on the right rear panel.
2. If you are using speakers, turn up the volume on your amplifier or mixer.
3. Slowly turn up the PC4 SE VOLUME Slider and play some notes to check the volume
level. (If you have a CC pedal plugged into the CC (VOLUME) jack, make sure it is set
to the maximum volume position).
4. If you are using speakers and the PC4 SE is not loud enough, turn up the volume on
your amplifier or mixer.
5. If you are using a mixer and hear distortion, reduce the gain level on the mixer, or use
the mixer's Pad button if it has one (a button that typically decreases the audio input level
by 20 dB).
6. After using the PC4 SE, if you are using speakers, turn the master volume all the way
down on your amplifier or mixer before powering off the PC4 SE.
Auditioning PC4 SE Sounds
1. The PC4 SE starts up in Program Mode. Use the NAVIGATION buttons, ALPHA
WHEEL, or CATEGORY buttons to select a different Program. See
page 1-13
1. To hear a Program Demo song for the current Program, press the KEYPAD and ENTER
buttons simultaneously.
2. To hear the capabilities of the PC4 SE, you can play the multi-channel demo songs. Press
the KEYPAD and 0/MISC buttons simultaneously to listen to a multi-channel demo
song.
3. To switch between auditioning Programs or Multis, press the PROGRAM or MULTI
Mode button under the MODE label to the right of the display.
for more details on selecting Programs or Multis.
Getting Started
Quick Start
PC4 SE Sounds on
1-3