Kurzweil PC4 SE Musician's Manual page 136

Global Mode
Main 2 Page
Switch Pedal Overrides
The Switch Pedal Override parameters (SW1A-SW2B Override) allow the controller
assignments for the Switch Pedals to be changed for all Programs and Multis. (KB3 organ
programs have a separate override for the SW1A pedal, see the Rotary Override section below
for details.) The alternative assignments available for the Switch Pedal Overrides include
the standard pedal controls of Sustain, Sostenuto and Soft as well as Data Inc, Data Dec,
Favorite Inc and Favorite Dec, which can be used to change Programs, Multis or Favorites
spots by using a pedal.
Use the Data Inc and Data Dec assignments (data increment/decrement) to select the next
or previous ID when you depress the pedal. If you are in Program mode, Data Inc and Data
Dec will select the next or previous Program. If you are in Multi mode, Data Inc and Data
Dec will select the next or previous Multi.
Use the Favorite Inc and Favorite Dec assignments (Favorites increment/decrement) to select
the next or previous Favorites spot when you depress the pedal. If you do not have a Favorites
spot selected, Favorite Inc and Favorite Dec will select the first Favorites spot, or the last spot
that was selected since turning on the PC4 SE.
Use the Arp On/Off and Arp Latch assignments to easily control arpeggiator functions.
The Arp On/Off assignment allows you to toggle the arpeggiator on and off by pressing
a switch pedal. The Arp Latch assignment allows you to latch held notes to be played by
the arpeggiator by holding down a switch pedal. When using the Arp Latch assignment,
make sure the arpeggiator is turned on. Play the notes you wish to latch, press and hold the
assigned pedal, then release the notes. The notes will continue to arpeggiate until the pedal is
released. (The functionality may differ depending on the current arpeggiator Latch settings,
see Latch on page 3-14
In Multi Edit Mode, if a pedal is selected which has a pedal override enabled in Global
mode, a message "Global Pedal Override is enabled" will display when that pedal is viewed to
remind you that the Global mode pedal override settings are being used instead of the Multi
mode pedal settings.
In Multi Edit Mode, setting a Pedal Mode to "Off" will disable the override for that Pedal
in the selected Zone. It can be useful in Multi Mode to disable the Pedal Override for some
Zones. For example, you may want to use a Pedal Override to control Sustain in all Zones of
a Multi, but disable Sustain for one Zone.
When a Pedal Switch Override is used, the pedal will behave in Multi Mode as if the
OnValue and OffValue are set to 127 and 0 respectively (this will not be shown in Multi Edit
Mode). When a Pedal Switch Override is set to Sustain, Sostenuto or Soft, the pedal will
behave in Multi Mode as if Pedal Type is set to Momentary (this will not be shown in Multi
Edit Mode). When set to Data Inc, Data Dec, Favorite Inc or Favorite Dec the pedal will
behave in Multi Mode as if Pedal Type is set to Toggle (this will not be shown in Multi Edit
Mode).
6-8
for details.)