Common Page - Kurzweil PC4 SE Musician's Manual

Multi Edit Mode

Common Page

Experiment by adjusting the scale value until the highest desired note is triggered at the
top of the controller's physical range. See
parameter. For shift patterns with more than 12 steps, you will run out of controller values
before your shift pattern triggers in every octave. If you want to be able to access all of the
available octaves, you can achieve this by setting multiple controllers to Shift Key Number.
Next, use the Scale and Add parameters for each controller, adjusting each to trigger the
desired range of octaves (see
Common Page
Tempo
Use the Tempo parameter to set the rate of the Arpeggiator or tempo synced FX (such as
Delay). You can set a value by using the ALPHA WHEEL, or by using the keypad function
of the CATEGORY buttons to type a value followed by pressing the ENTER button.
The value of the Tempo parameter can also be set by tapping the TAP TEMPO button at the
desired rate.
Clock Source
Use the Clock Source parameter to set whether the selected Multi will use its own tempo, or
whether it will sync with the tempo from an external MIDI device.
Set the Clock Source parameter to Internal to use the tempo set by the Tempo parameter.
Set the Clock Source parameter to External to use the tempo from an external MIDI device.
When the Clock Source parameter is set to External, an external MIDI device must be
sending MIDI clock data to the USB or MIDI in port.
5-38
Scale on page 5-28
Add on page 5-28).
for more details on the Scale