Kurzweil PC4 SE Musician's Manual page 106

Multi Edit Mode
Arpeggiator, CC Seq and Riff Page
Re-Channel
Song Track numbers and Multi Zone numbers have matching MIDI channel numbers by
default. When the current zone's MIDI channel and the channel of the riff's selected Source
Track do not match, it can make the riff play programs from other Zones. To prevent this
you can use the Re-Channel parameter.
When Re-Channel is set to On, the track selected for the Source Track parameter will play
through the MIDI channel of the current zone. For example, if you want to use a riff on zone
2 (set to use MIDI channel 2) and the riff was recorded on track 4 (set to use MIDI channel
4), you will need to turn Re-Channel on. If you were to do this and keep Re-Channel set to
Off, the riff would play using the program from zone 4 (set to channel 4) instead of zone 2.
When Re-Channel is set to On and Source Track is set to All, all of the tracks of the song
will play through the MIDI channel of the current zone.
Trigger Range
Use the Trigger Range parameters to set the keyboard range that will trigger the Riff. The
left and right Trigger Range parameters set the lowest and highest keys that will trigger the
Riff. For a key to trigger a riff, the key must also be within the Zone's Key Range (set on the
Overview page).
You can select a key using the ALPHA WHEEL, or by pressing and holding the ENTER
button and pressing the desired key.
Note: Riffs can also be triggered and released by assigning a controller destination 163 Riff
OnOff.
Release Range
Use the Release Range parameters to set the keyboard range that will stop the Riff when a
key is released. The left and right Release Range parameters set the lowest and highest keys
that will stop the Riff when a key is released. For a key to stop a riff, the key must also be
within the Zone's Key Range (set on the Overview page).
You can select a key using the ALPHA WHEEL, or by pressing and holding the ENTER
button and pressing the desired key.
Note: Riffs can also be triggered and released by assigning a controller destination 163 Riff
OnOff.
Conditional Release (Condit. Rel)
When the Condit. Rel parameter is set to On, the riff will play when a key is pressed and
held, and other keys will not stop or restart the riff until the key original key is released. To
use conditional release, set the same range for the Trigger Range and Release Range. To stop
the riff, release the original key.
5-18