Kurzweil PC4 SE Musician's Manual page 113

Switch Controllers
This section describes parameters for the following switch controllers:
• SW pedal jacks 1 and 2 (Up to 2 pedals per jack: Sw.Pedal 1a, 1b, 2a, 2b)
• VARIATION button
• ARP button (Arp On/Off)
• LATCH button (Arp Latch)
• CC SEQ button
• CONTROL buttons 1-5 (Switch 1 - Switch 5)
Controller
Use the Controller field to select a controller and view the controller settings for each Zone.
When the Controller field is selected, you can select a controller by using the ALPHA
WHEEL, or by holding the ENTER button and moving a controller.
If a pedal is selected which has a pedal override enabled in Global mode, a message "Global
Pedal Override is enabled" will display when that pedal is viewed to remind you that the
Global mode pedal override settings are being used instead of the Multi mode pedal settings.
Mode
When Mode is set to Off, the controller is disabled for this zone.
When Mode is set to MIDI CC, the controller can send MIDI control messages.
Type
Use the Type parameter to set a switch controller to Momentary or Toggled. This parameter
affects the selected switch controller for all Zones.
When Type is set to Momentary, the switch controller sends its "On Value" when pressed,
and its "Off Value" when released.
When Type is set to Toggled, the switch controller alternates between sending its "On Value"
or "Off Value" each time it is pressed. No value is sent when the controller is released.
Multi Edit Mode
Controls Page
5-25