Kurzweil PC4 SE Musician's Manual page 171

Quantize
The Quantize parameter determines the amount of real-time quantization (if any) applied to
the sequence during recording. The percentage specified for this parameter is the amount of
quantization the sequencer applies to the grid (see below) for each Note event recorded.
Note that using real-time quantization has the same effect as recording normally, and then
using the Quantize Track Editing operation.
Grid
The grid parameter determines the resolution of quantization and the position of the grid
points.
Swing
The Swing parameter determines the amount (in units of percent) of "swing" applied during
quantization.
Release
The Release parameter determines whether or not note-off events are quantized.
Metronome Parameters
Metronome
This parameter determines the recording modes in which the metronome plays. With
Metronome set to Off, the metronome never plays. With Metronome set to Rec, the
metronome only plays during recording. With Metronome set to Always, the metronome
plays during playback and recording. With Metronome set to CountOff, the metronome
plays only during count off (if the CountOff parameter is set to something other than Off).
Count Off
This parameter determines the number of measures the PC4 SE will count off before
recording. With Start Only selected, the PC4 SE will only count off at the beginning of a
sequence. With Always selected, the PC4 SE will count off from any point in a sequence.
Program
This parameter determines the program with which the metronome is played.
Song Mode
Misc Page
7-15