User Tool Settings For Ieee 802.11A/B/G/N - Ricoh SP 8400DN Field Service Manual

IEEE 802.11a/b/g/n Interface Unit Type M19 (D3BR-01)
Attaching the Antenna
1.
Attach the velcro fastener [B] (provided with this unit) on the antenna [A].
•
Attach the velcro fastener to the bottom half of the case (where the cable is located).
•
You may attach the velcro fastener on either side of the case.
2.
Peel the backing paper off the velcro fastener, and attach the antennas [A] and [B] as shown.
•
When attaching 2 antennas, attach them at least 12 cm or more away from each other.
•
Take care to loop it around so that it does not interfere with other options or I/F cables.
3. Turn ON the main power.
4.
Print out the "Configuration Page", and then check if this option is correctly recognized.
•
User Tools > Machine Features > Printer Features > List/Test Page > Configuration Page

User Tool Settings for IEEE 802.11a/b/g/n

Go into the User Tools mode and do the procedure below. These settings take effect every time the machine is
powered on.
•
IEEE 802.11a/b/g/n function is disabled while using Ethernet.
1. Press the "User Tools" icon.
246