8.
Pull out the 1st/2nd paper feed trays, and then remove the orange tape.
Pulling out the Feeler of the Paper Exit Full Sensor
•
When a finisher is installed, the feeler does not need to be pulled out.
1.
Pull the sensor feeler [A] out.
Checking the Position of the Paper Exit Feeler
Check the following points for the paper exit feeler [A] installed at the paper exit.
•
It can move in line with the ejection of paper.
•
It holds contact with the surface of the ejected paper and is still movable.
Paper will get jammed in the following cases.
•
The paper exit feeler does not function due to obstacles (such as cables).
•
The paper exit feeler does not function when the paper is pulled out and pushed back again.
2.Installation
31