To Remove The Cd-Rom Drive - Nortel CallPilot 703t Maintenance And Diagnostics

Replacing media drives

To remove the CD-ROM drive

.
Note: The CD-ROM drive is installed in the top bay.
1 Prepare the server for CD-ROM drive replacement as follows:
a. Shut down the server, and then disconnect the power and
b. Remove the side cover.
c. Remove the upper fan holder foam.
For instructions, see "Preparing the server for hardware
maintenance" on page 120.
.
2 Disconnect the faulty drive's power and signal (IDE) cables.
3 Open the front panel on the server.
4 Remove and save the two screws that secure the CD-ROM drive to
the front of the chassis.
5 Pull the drive out of the chassis, and then place it on an antistatic
surface.
Note: If you plan to leave the bay empty, install a filler panel and
stainless steel EMI shield on the bay.
6 Remove the four screws and two slide rails from the drive.
162
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
peripheral device cables.
WARNING
Risk of personal injury or equipment damage
Failure to follow the procedures in "Preparing the
server for hardware maintenance" on page 120 can
result in electrical shock or equipment damage.
Standard 1.06
CallPilot