To Install A Replacement Floppy Disk Drive - Nortel CallPilot 703t Maintenance And Diagnostics

January 2007
3 Open the front panel on the server.
4 Remove and save the two screws that secure the floppy disk drive
to the front of the chassis.
5 Slide the assembly toward the back of the server to disengage it
from the tabs that secure the carrier assembly to the server.
6 Remove the assembly from the chassis.
7 Remove the four screws that hold the bracket to the drive, and set
them and the bracket aside.
8 Place the drive in an antistatic protective wrapper.
9 Continue with "To install a replacement floppy disk drive" on
page 167.

To install a replacement floppy disk drive

1 Remove the new floppy disk drive from its protective wrapper, and
place it component-side up on an antistatic surface.
2 Record the drive model and serial numbers in your equipment log.
3 Set any jumpers or switches according to the drive manufacturer's
instructions.
703t Server Maintenance and Diagnostics
Replacing media drives
167