Override Rotary Switch; Fig. 6-4: Override Rotary Switch - Bosch Rexroth VAM 10.1 Project Planning Manual

VAM 10.1 / VAM 40.1

Override Rotary Switch

DOK-SUPPL*-VAM*10/40**-PR02-EN-P
Two keypads each provided with 15 keys are available. The keys are
short-stroke keys and can be configured and labeled according to the
system requirements. The keys are covered by a foil arranged in a matrix
containing three columns and five rows for each keypad. Each key is
illuminated by a green point LED.
There are separators between the keys preventing the user from
accidental key activation, as they separate clearly one key from each
other.
The module is connected to the logic board via the internal shift register
bus. The states of the pushbuttons are transmitted to the master control
via PROFIBUS DP. The LEDs are triggered via PROFIBUS DP by the
master control.
Note: The module configuration as well as the address assignment
is described in chapter 8 "Commissioning".
Fig. 6-4: Override rotary switch
This module slot is equipped with two override rotary switches. The feed
override has 16 switching positions ranging from "0 to Max", the spindle
override has also 16 switching positions ranging from "Min to Max".
The module is connected to the logic board via the internal shift register
bus. The switching positions of the pushbuttons are transmitted to the
master control via PROFIBUS DP.
Note: The module configuration as well as the address assignment
is described in chapter 8 "Commissioning".
3
Module Layout
Override_Drehschalter.FH9