Characteristics Of Digital Inputs; Characteristics Of Digital Outputs; Connection For External Hand-Held Terminal (X81); Fig. 7-8: Characteristics Of Digital Inputs - Bosch Rexroth VAM 10.1 Project Planning Manual

VAM 10.1 / VAM 40.1

Characteristics of Digital Inputs

Characteristics of Digital Outputs

7.6

Connection for External Hand-Held Terminal (X81)

DOK-SUPPL*-VAM*10/40**-PR02-EN-P
Input type
Number of inputs
Status display by LED
Electrical isolation
Reverse voltage protection
Plug-in grid
Fig. 7-8: Characteristics of digital inputs
Output type
Number of outputs
Status display by LED
Electrical isolation
Reverse voltage protection
Output voltage, nominal value
Rated output current
nominal value:
UL rating:
Simultaneity factor
Plug-in grid
Fig. 7-9: Characteristics of digital outputs
Besides the inputs for the handwheel of the hand-held terminal (A, /A, B,
/B) 12 inputs (IN0 – IN11) for the keys of the hand-held terminal are
available. The keys are supplied via the "+24 V" supply via connector X81.
The "+24 V" supply is generated by the supply "UL" and may only be used
to connect the keys of the hand-held terminal. Connection X81 for the
hand-held terminal is located on the logic circuit.
The states of the inputs and the counter value of the handwheel are
transmitted to the master control via PROFIBUS DP.
Note: The module configuration as well as the address assignment
is described in chapter 8 "Commissioning".
Type 1, according to EN 61131-2
16
Green
Yes (to logic supply)
Yes
3,5 (Weidmüller terminal)
Semiconductor outputs, non-saving;
protected, with automatic restart, current-
carrying
8
Green
Yes (to logic supply)
Only guaranteed without load connection
Defect of the assembly because of
•
Polarity reversal with simultaneous short-
circuit of the output lines,
•
Polarity reversal with simultaneous
connection of externally polarized
suppressor diodes at the output lines
•
Applying an external voltage > U
24 V
0,2 A
0,2A General Purpose
5W Tungsten
100 %
3,5 (Weidmüller terminal)
7-5
Interfaces
Q