Wiring; Terminal Blocks - Omron SYSDRIVE 3G3XV-EV2 Series Operation Manual

Wiring

Voltage Phase
200 V 3-phase
Single-phase
400 V 3-phase
1-4

Wiring

Note

1-4-1 Terminal Blocks

Removing/Attaching the Terminal Cover
W1
W
Max. Applicable
Motor Output HP (kW)
0.13 to 0.5 (0.1 to 0.4)
1/2 (0.75/1.5)
3/5 (2.2/3.7)
0.13 to 0.5 (0.1 to 0.4)
1/2 (0.75/1.5)
3/5 (2.2/3.7)
0.25/0.5 (0.2/0.4)
1/2 (0.75/1.5)
3/5 (2.2/3.7)
Connect the main circuit and control circuit wiring securely, as
described below.
Use closed-loop connectors sized for the gauge of wire being
used. Attach the connectors using a crimping tool recommended
by the connector manufacturer.
The main circuit and control circuit terminal blocks are at the bot-
tom of the Inverter under a terminal cover.
To remove the terminal cover, squeeze the sides of the cover (1),
and lift up (2) at the same time, as shown in the following diagram.
Reverse these steps to attach the cover.
H1 H
Four, d dia.
W W1 H
4.13 3.66 5.91
(105) (93) (150)
5.51 5.04 5.91
(140) (128) (150)
5.51 4.96 7.87
(140) (126) (200)
5.51 5.04 5.91
(140) (128) (150)
5.51 4.96 7.87
(140) (126) (200)
7.48 6.89 7.87
(190) (175) (200)
5.51 4.96 7.87
(140) (126) (200)
5.51 4.96 7.87
(140) (126) (200)
7.48 6.89 7.87
(190) (175) (200)
Section 1-4
D
H1 D d
5.43 3.94 0.20
(138) (100) (5)
5.43 5.43 0.20
(138) (138) (5)
7.32 6.69 0.22
(186) (170) (5.5)
5.43 5.43 0.20
(138) (138) (5)
7.32 6.69 0.22
(186) (170) (5.5)
7.28 7.48 0.23
(185) (190) (5.8)
7.32 4.72 0.22
(186) (120) (5.5)
7.32 6.69 0.22
(186) (170) (5.5)
7.28 7.48 0.23
(185) (190) (5.8)
5