Setting Before Operation - Omron SYSDRIVE 3G3XV-EV2 Series Operation Manual

Operation

1-5-2 Setting Before Operation

Set Value Prior to
Shipping
Since the standard Inverter Models are shipped with the default
values listed in 2-7 Function/Constant List , the Digital Operator
must be used in order to change the constants from the initial val-
ues to values in accordance with the load specifications.
The following describes the functions and initial constant set val-
ues which are often used for operation.
Output Frequency and Accel/Decel Time:
The maximum output frequency is set to 60 Hz and accel/decel
time to 10 seconds at the factory prior to shipping. To change the
values, refer to 2-8-6 Accel/Decel Time and Patterns .
60
Output freq.
(Hz)
0
10"
Accel time
Frequency Setting Signal and Output Frequency:
The figure below shows the Inverter output frequency for control
circuit terminal master frequency reference voltage. To change the
value, refer to 2-8-7 Output Frequency Control (Gain/Bias) .
60
Output freq.
(Hz)
1.5
0
Freq. setting voltage (V)
10"
Decel time
10 V
Section 1-5
17