Changing Decurling Bar Radius - GBC DELTA Operator's Manual

Delta Laminator
Operator Manual

13.2 CHANGING DECURLING BAR RADIUS

If a line is apparent on the laminated sheet, radius R3 of the decurling bar (a) can be used for thin
paper. The line is caused by the decurling bar edge.
To change the radius of the decurling bar:
1. Loosen the four M8 screws.
2. Turn the decurling bar (a) over end to end to the desired radius. R2 has a 5/64 in. (2 mm) radius and R3
has a 7/64 in. (3 mm) radius.
R2
R3
M8
a
M8
56 © 2004 General Binding Corporation