Table of Contents
Advertisement
(G)
(I)
(F)
(H)
(L)
(J)
24
(1)
(E)
Fig. 11
(H)
Fig. 12
(L)
Fig. 13
E. SAFETY SHIELD: (Figure 11)
Prevents entanglement, entrapment
and inadvertent contact with the
heat rollers. The laminator will
operate only when the Safety
Shield is located in the fully
locked and closed position.
Power to the motor is
removed when the shield is in
the open position or the
interlock latch is unlocked.
To remove the safety shield, unlock
the safety shield interlock latch and
lift the the safety shield (1) up and
away from the safety shield
mounting pins (2).
F. FEED TABLE: (Figure 12) The
(2)
Feed Table is used to position items
for lamination. To pivot the feed
table, remove the safety shield, lift
up on the feed table, pull back,
then carefully lower. The
laminator will operate only
when the Feed Table is
properly installed.
NOTE: You can not raise or
lower the main rollerwith the
table pivoted.
G. CHILL IDLER: (Figure 12) Assist
in the cooling process of the web
material as it exits the heat rollers.
To remove the chill idler, lift the chill
idler straight up and out from the
chill idler brackets.
H. FILM SHAFT: (Figure 12)The film
shaft holds the film supply on the
machine.
I. MAIN ROLLERS: (Figure 12)
Silicone rubber coated steel tubes
heat the laminating film and
compress the heated film to the
items being laminated. Heat is
provided by an internal heating
element. The heat rollers are motor
driven for ease of loading new film.
J. IDLER BAR: (Figure 13) The idler
bars, located near each heat roller,
are used to direct the film to the
heat roller nip. The bottom Idler Bar
is movable to ease film loading.
(K)
K. PULL ROLLERS: (Figure 13)
The pull rollers, located at the back
of the laminator, are motor driven.
They simultaneously pull the film
and improve the quality of the
laminated item.
L. REWIND TUBE: (Figure 13) The
front rewind tube is used to rewind
release liner while the rear botom
rewind tube is used to rewind
finished product. To remove the
rewind tube, push the tube against
the rewind brake and remove the
tube from the rewind support side.
Preliminary
Copy
I
Advertisement
Table of Contents
