Mechanical Service; Feeder Table - GBC DELTA Operator's Manual

Delta Laminator

2. MECHANICAL SERVICE

2.1

FEEDER TABLE

The feeder table is suspended on two roller chains and guided on two guide bars. Only a technician
trained by GBC Service can change or tighten the roller chains.
2.1.1 Chain Tension Adjustment
•
The solid safety covers do not have to be removed for tightening the chains.
•
Tighten the chains using the tightening screws on the feeder frame.
2.1.2 Chain Replacement
1. Disassemble the sheet metal safety covers.
2. Disconnect the chain from the tightening screws.
3. Take the old chain off.
4. Put a new chain on.
5. Connect the chain to the tightening screws and tighten the chains so that the table will go up
evenly in the horizontal position.
6. Install the sheet metal safety covers.
2.1.3 FEEDER TABLE TROUBLESHOOTING
•
The feeder table moves uneasily although a stack is not loaded.
Check the tighteness of the chains or tighten the chains properly. Clean or oil the guide strips.
•
The automatic feeder table lifting is not working reliably.
The problem can be removed only by a GBC Service technician. Maintenance consists of
regular lubrication of the functional parts according to the lubrication plan and removal of the
excess grease and dust.
© 2004 General Binding Corporation
Service Manual – Mechanical
Tightening
screw
7