Table of Contents
Advertisement
62FM L
AMINATOR
I
B
DLER
AR
The idler bars, located near each heat roller, are used
to direct the film to the heat roller nip.
C
I
HILL
DLER
Assist in the cooling process of the web material as it
exits the heat rollers.
To remove the chill idler, lift it out of its cradle and set
aside, taking care to not damage the bearings.
C
F
OOLING
AN
Assist in the cooling process by pushing unheated
air onto the web
P
R
ULL
OLLERS
The pull rollers, located at the back of the laminator,
are motor driven. They simultaneously pull the film
and improve the quality of the laminated item.
Rewind tube
Core Chuck
Idler bar
Chill idler
Pull roller
Rear table
Fig. 5-7. Rear View of 62FM.
R
T
EAR
ABLE
Provides a working surface when operating the
machine from the rear. This table may also be
lowered when webbing for roll to roll applications.
To lower, slide the left and right side rear table
latches to the unlatched position and lower the rear
table.
C
C
ORE
HUCKS
Hold and lock the rolls of film on the shafts to
prevent side to side shifting.
S
B
EPARATOR
AR
(Optional) Required if running AccuShield material.
5-6
R
H
OLLER
ANDLE
The roller handle manually sets the position of the
pull rollers while simultaneously electronically setting
the main rollers.
Fig 5-8. Roller Handle.
Available settings are;
•
Release
•
1/2 in. Mounting
•
3/8 in. Mounting
•
3/16 in. Mounting
•
1/8 in. Mounting
•
Low Laminating
•
Mid Laminating
•
High Laminating
F
W
ILM
EB
(Not shown.) The path the laminating film and/or
mounting film mounted on the machine takes
through the machine.
N
P
IP
OINT
The point at which the top and bottom rollers come
into contact. The Nip Point of the heat rollers is
the place at which the items for lamination are
introduced into the laminator.
Operating Instructions
Advertisement
Table of Contents
