Changing The Master Ip Address; Configuring The Wlan Ip Telephony Manager 2245 - Nortel 2245 Installation And Configuration Manual

Changing the master IP address

Configuring the WLAN IP Telephony Manager 2245

WLAN IP Telephony Manager 2245 configuration
3 Alternatively, select the Reset option found in the SVP-II Configuration
screen. Press Esc. See "Configuring the WLAN IP Telephony Manager
2245" on page 77.
To change the IP address of the master WLAN IP Telephony Manager 2245,
change it in the Network Configuration menu and reboot the system. Then
alias IP addresses can be changed in each of the other WLAN IP Telephony
Managers 2245 without incurring an error.
The WLAN IP Telephony Manager 2245 is configured on the
Configuration
screen where the mode of the WLAN IP Telephony
Manager 2245 is configured. This screen is also used to lock the WLAN IP
Telephony Manager 2245 for maintenance and reset the WLAN IP
Telephony Manager 2245 after maintenance.
The WLAN IP Telephony Manager 2245 automatically locks for
maintenance if the IP address is changed. When a Maintenance Lock occurs,
the WLAN IP Telephony Manager 2245 must be reset upon exit. All active
calls are terminated during a reset.
Access the SVP-II Configuration screen from the NetLink SVP-II System
menu. Scroll to SVP-II Configuration and press Enter.
The SVP-II Configuration screen is shown in Figure 8 on
Perform the desired SVP-II configuration.
End of Procedure
WLAN IP Telephony
Page 77 of 206
SVP-II
page 78.
Installation and Configuration