Continuing Configuration Through Telnet; Connecting Through Telnet - Nortel 2245 Installation And Configuration Manual

Figure 28
WLAN Application Gateway 2246 connection to Application Server through a modem
LAN
Ethernet
switch

Continuing configuration through Telnet

Connecting through Telnet

Appendix A: WLAN Application Gateway 2246
Connect to Application Server through a modem
Connect the modem to the Gateway's serial port using a cable that conforms
to RS-232 standards for DTE-to-DCE connections. See Figure 28.
WLAN Application
Gateway 2246
Once the IP address for the WLAN Application Gateway 2246 has been
configured and reset, and the WLAN Application Gateway 2246 has been
connected to the LAN and the Application Server, Telnet can be used to
continue the WLAN Application Gateway 2246's configuration.
Connection to the WLAN Application Gateway 2246 can be done through the
network using Telnet. Telnet can only be used after the WLAN Application
Gateway 2246's IP address has been configured.
The Telnet method of connection is used for routine maintenance of the
system for both local and remote administration, depending on the network.
Follow the steps in Procedure 22 to connect to a WLAN Application Gateway
2246 through Telnet.
modem
DCE
DTE
RS-232
port
WLAN IP Telephony
Page 173 of 206
Dedicated
phone line
Installation and Configuration