Site Certification; Testing Signal Strength With The Wlan Handset 2210/2211 - Nortel 2245 Installation And Configuration Manual

Site certification

Testing signal strength with the WLAN Handset 2210/2211

WLAN Handsets 2210/2211 configuration
5 Press the Power On / Start Call key. Any line indicators turn off and the
extension number display returns.
Ensure the wireless handsets are adequately supported by the site.
Conduct a Site Survey. Note any areas where coverage is conflicting or
inadequate. Note any system difficulties and work with the system
administrator to determine the cause and possible remedy. Refer to
"Conducting an effective site survey" on
conducting a site survey. Refer to "Troubleshooting the WLAN Handset
2210/2211" on page 133
The testing must be performed in typical operating conditions, especially if
heavy loads occur. Generally, organize the test according to area and volume,
placing numerous calls to others who can listen while coverage tests are
performed. Note any areas with excessive static or clarity problems and report
it.
This test can only be performed if the Nortel Networks WLAN system has
been installed and configured.
Follow the steps in Procedure 13 to test AP signal strength using the wireless
handsets.
Procedure 13
Testing signal strength using the wireless handset
1 Test signal strength in the covered area by putting a WLAN Handset
2210/2211 in Site Survey Mode.
Refer to "Site Survey Mode" on
2 Walk the entire coverage area while viewing the display.
End of Procedure
page 35
for clues to possible sources of difficulties.
page 93.
WLAN IP Telephony
Page 107 of 206
for information on
Installation and Configuration