Table of Contents
Advertisement
Operator's Manual: Seed Titan
4.3.4 Drive Belt Installation:
See Figure for the correct routing of the drive
belt. Always check the alignment of the pulleys
when replacing the belt.
4. Tighten the jam nut.
5. Tighten the four engine mounting bolts.
6. Tighten the engine base stabilizing bolt.
10.8.2 Drive Belt Installation
Use the following photo for the correct routing of
the drive belt. Always check the alignment of the
pulleys when replacing the belt.
Fig 69 - 2SE Drive belt routing
Fig 70 - 4SE drive belt routing
Revised 02.2021
2SE/4SE Box Seed Tender
™
4.3.5 Battery Maintenance/Replacement:
Inspect the battery at least once every six
months and before using the seed tender at
the beginning of the season. Always follow the
safety instructions when servicing a battery.
• Check the batteries at least every six months
for low Voltage, leakage, etc.
• Always use the correct size and type of battery.
Replace old batteries with a new SP-30 Lawn
and Garden battery with 230 CCA and 290 CA
ratings.
• Do not install the battery cable to the wrong
terminal. Make sure the RED cable is connected
to the + (plus) terminal and the BLACK cable is
connected to the – (minus) terminal.
• Remove the batteries from the seed tender if
not expected to be in use for several months.
• Use recommended practices when recharging
a dead battery.
• Remove any corrosion from the battery post
using a wire brush terminal cleaner. Corrosion
can also be removed using a baking soda
paste and water to neutralize and remove the
acid from the battery terminals.
• Dispose of old batteries properly.
• Make sure the tie-down strap is connected
to the frame of the battery box and in good
condition (not cracked, cut, or damaged).
• The battery is not charged when the engine is
operating. If the battery is not charging using
an external charger, check the fuse. Replace
the fuse if necessary.
4-9
Advertisement
Table of Contents
