Table of Contents
Advertisement
Operator's Manual: Seed Titan
4.2.3 Every 100 Hours or Monthly:
12. Grease conveyor belt roller bearings.
13. Check wheel nuts.
- Torque to 90-120 ft-lb
14. Adjust the trailer brakes.
15. Inspect tires for wear.
16. Grease the axles.
17. Inspect brake magnets for wear.
18. Inspect suspension parts for wear.
19. Check battery electrolyte levels, and clean
terminals to remove dirt and corrosion.
4.2.4 Every 200 Hours or Annually:
20. Change the engine oil.
21. Change Reduction Case Oil.
22. Check that battery retains maximum charge.
23. Inspect the tires for wear.
24. Inspect brake lining wear:
- Check brake cylinder for leaks.
- Inspect brake wiring for damage.
-
25. Repack the wheel bearings:
- Check for excessive play in the bearings.
- Grease the wheel bearings.
26. Check the wheel hub for wear.
27. Inspect axle grease seal for leakage.
28. Inspect springs for any wear or loss of arch.
29. Inspect all electrical wiring connections for
looseness or corrosion.
- Tighten and/or seal, as necessary.
4-4
2SE/4SE Box Seed Tender
™
30. Check trailer axle, frame, hitch and tender
hold-down bolts.
- Refer to Section 6.2 Bolt Torque.
31. Check conveyor tube and bearing bolts.
32. Thoroughly clean the tender.
- Wash to remove all dirt, mud, debris and
residue.
- Wash around and inside the intake hopper
and chutes.
- Clean inside the conveyor tube, and belt.
Fig 58 - Grease roller bearings
Fig 59 - Trailer wheels
Revised 02.2021
Advertisement
Table of Contents
