Table of Contents
Advertisement
Operator's Manual: Seed Titan
4.3.8 Conveyor Belt Replacement:
If the belt is unbroken, it may be possible to
use the old belt to thread the new belt into the
delivery tube.
1. Position tube for easy access to both ends.
2. Open the clean out door.
3. Loosen the lower drive drum adjusting bolts.
4. If the old belt can be used to install the new
belt, continue with this step; if not, continue
to Step 5.
a. Remove belt guard to access belt lacing.
a. Disconnect the lacing.
b. Attach the replacement belt to the end of
the old conveyor belt.
c. Slowly pull the old belt out of the spout,
threading the new one into position.
d. Disconnect the old belt and connect the
lacing of the new belt together.
5. If the old belt cannot be used:
a. Remove the delivery spout.
a. Remove the galvanized belt guards.
b. Thread the new belt through the tube.
c. Connect the two ends of the belt lacing.
6. Tighten the two drive drum tension bolts
equally to 23 ft-lb. While holding the adjusting
bolt in place, retighten both locking nuts.
7. Start the engine. Run the conveyor to make
sure the belt tracks properly.
- If the belt does not track properly, refer to
Section 4.3.8 Belt Tracking instructions to
correct the problem.
8. Recheck the tension and alignment of the
belt frequently during the first ten hours of
operation and adjust, as needed.
Note:
The belt normally seats itself during
the first 10 hours of operation
and can be checked weekly
Revised 02.2021
2SE/4SE Box Seed Tender
™
Fig 73 - Conveyor tube access door
Fig 74 - Belt Tension bolts
Fig 75 - Conveyor belt lacing
Fig 76 - Delivery spout
4-11
Advertisement
Table of Contents
