Meridian SEED TITAN 2SE Operator's Manual page 37

Operator's Manual: Seed Titan
UPENDING HAZARD
Always unload rear seed boxes first to maintain
a positive tongue weight. Negative tongue
weight can cause the hitch to rapidly swing
upward if not securely fastened to the tow
vehicle, which can result in personal injury.
11. Lift the lock plate (1) to release the slide gate
handles.
Note:
Figure 51 shows the lock plate in the
open position, which will allow the slide
gates to open. Figure 52 shows the lock
plate in the closed position.
12. Pull the handle to open the slide gate.
- Close slide gate by pushing the handle in.
13. Fill the planting equipment.
a. Move delivery spout to the planter bin.
b. Increase engine RPM to start conveyor
belt rotating.
c. When the bin is full, reduce the engine
RPM to low idle which will stop the
conveyor belt.
d. Repeat this process until planter is full.
14. When the job is done, close the seed box
slide gate.
15. Close the lock plate.
16. Reduce engine RPM to stop the conveyor
belt.
IMPORTANT:
If the tender will not be used again for an
extended period of time, the tube should be
cleared of all seed. This will help prevent
the tube from being clogged with seed.
Revised 02.2021
2SE/4SE Box Seed Tender
™
Fig 51 - Lift lock plate to use slide gate handles
Fig 52 - Lock plate in "locked/closed" position
Fig 53 - Fill planter bin
3-17