Greasing - Meridian SEED TITAN 2SE Operator's Manual

Operator's Manual: Seed Titan

4.1.1 Greasing:

Use an SAE multipurpose high temperature
grease with extreme pressure (EP) performance.
Also acceptable, SAE multipurpose lithium
based grease.
GREASING HAZARD
Too much grease causes excessive overheating.
Under-greasing accelerates equipment wear.
No grease should be seen around bearings.
If there is, too much grease was applied
and the seal has ruptured!
IMPORTANT:
Grease bearings only one pump per month
under normal usage conditions.
Bearing greasing frequency should be
determined by usage and conditions.
1. Use a hand-held grease gun for all greasing.
2. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
3. All bearings are greasable, but require only
minimal grease.
Recommended greasing is one small stroke
every month. Be careful not to over-grease
as this may push the seal out.
4. Replace and
immediately.
5. If fittings will not take grease, remove and
clean thoroughly. Also clean lubricant
passageway. Replace fitting if necessary.
4-2
2SE/4SE Box Seed Tender
™
repair broken fittings
Fig 55 - Seed Titan 2SE
™
Fig 56 - Seed Titan 4SE
™
Revised 02.2021