Table of Contents
Advertisement
Operator's Manual: Seed Titan
7. Press and hold the remote throttle switch to
move the throttle lever 1/3 the distance of
the full open position.
- An electronic actuator is connected to the
throttle lever to increase and decrease the
speed of the engine.
8. Start the gas engine.
a. Move fuel valve lever (3) to the ON
position.
b. To start a cold engine, move choke lever
(4) to the CLOSED position.
c. Turn the key switch to the START
position. Release the key switch when
the engine ignites.
9. Allow the engine to warm up for two or three
minutes. If the choke was closed to start
the engine, gradually open it as the engine
warms up.
10. If necessary, decrease the engine speed
below 1400 RPM using the remote throttle
control switch.
- The centrifugal clutch on the engine will
engage and rotate the conveyor when the
engine speed exceeds 1400 RPM.
- Increasing the engine speed will increase
the unloading rate.
3-16
2SE/4SE Box Seed Tender
™
Fig 47 - Remote throttle switch
Fig 48 - engine controls
Fig 49 - Start the engine
Fig 50 - Remote throttle control switch
Revised 02.2021
Advertisement
Table of Contents
