Conveyor Belt Tension; Conveyor Belt Alignment - Meridian SEED TITAN 2SE Operator's Manual

Operator's Manual: Seed Titan

4.3.6 Conveyor Belt Tension:

1. Loosen the locknut on each side of the belt
tension mechanism.
2. Tighten the two adjusting bolts equally to
23 ft-lb. While holding the adjusting bolt in
place, retighten both locking nuts.
3. Start the conveyor and make sure the belt is
tracking in the center of the drive drum.
- If the belt is not tracking properly, use the
Belt Tracking Adjustment procedure to
correct the problem.

4.3.7 Conveyor Belt Alignment:

IMPORTANT:
The drive drum, at the bottom of the
conveyor must be square (drive shaft
must be equal distance from end of
unit) for the belt to track properly.
Note:
If belt is not tracking correctly,
it will move to the loose side.
Tighten loose side or loosen tight side.
1. Adjust one side at a time.
- Loosen the locking nuts on the adjusting
bolt.
2. Tighten or loosen the bolt on one side, below
the delivery spout, to correct the tracking
problem.
3. Using a wrench, hold the adjusting bolt in
place while tightening the locking nut against
the housing.
4. Slowly, test run the conveyor belt.
- Check if the belt is tracking centered.
- Re-adjust, if needed.
4-10
2SE/4SE Box Seed Tender
™
Fig 71 - Conveyor belt tension bolt
Fig 72 - Conveyor belt tracking adjustment bolts
Revised 02.2021