Table of Contents
Advertisement
Operator's Manual: Seed Titan
Break-Away Switch:
A Break-Away Switch is installed on all trailers.
The control box contains LEDs to show the
condition of enclosed battery. There is a Test
button to check the battery level.
IMPORTANT:
Test the Break-Away Switch periodically.
Removing the pin, then pull the trailer
to feel if the brakes have engaged.
The cable attached to the Break-Away Switch
pin, must go around the ball before coupling the
trailer to the tow vehicle.
During transportation, if the trailer should detach
from the transport vehicle, the pin will be pulled
out engaging the trailer's brakes.
TRANSPORT HAZARD
Always secure the safety chains
to the tow vehicle, in addition
to the Break-Away Switch.
Weigh Scale Package (Optional):
A scale package allows the seed to be weighed
as the tender is being filled or as it is emptied
into the planter.
Refer its manual for all the information.
Revised 02.2021
2SE/4SE Box Seed Tender
™
10.9 TRAILER BREAK-AWAY SYSTEM
Fig 21 - Break-Away system
10.9.1 Testing the Battery
1. Disconnect the trailer plug from the tow
vehicle; otherwise, you are testing the tow
vehicle's battery.
2. Press the green TEST button on the control
box located inside the frame of the trailer. The
green indicator light should illuminate if the
battery is fully charged. If the yellow or red
Fig 22 - Weigh Scale Display
indicator lights illuminate, the unit's battery
should be charged before towing the trailer.
IMPORTANT
If the battery is weak or dead (red indicator, even
after charging), as indicated by the indicator light,
the battery must be replaced.
3. Plug the trailer into the tow vehicle. The
yellow "Charging" light should be ON.
4. Test the system by pulling the pin out of the
break-away switch. The battery will activate
the brakes. (Note: Do not use this kit as
a parking brake). The battery should be
charged and tested prior to each trailer outing.
10.
The
rech
repl
10.
The
repl
repl
a re
10.
RE
3-7
1.
Advertisement
Table of Contents
