Polaris Sportsman 850 Service Manual page 229

3. Remove the four screws
(helix) assembly using a T25 Torx driver.
4. Place the driven clutch into the Universal Clutch
Compressor.
Universal Clutch Compressor:
PU-50518-A
5. Press down on the top of the spider assembly,
pushing the spider onto the shaft. Remove snap ring
e
and slowly release the assembly.
w
that secure the cam 6. Remove the spider assembly and spring.
NOTE
Spring is compression only and has no torsional wind.
7. Remove the E-clips, washers, and the clutch rollers.
Inspect the rollers for wear; replace if worn.
o
8. Press out the spring pins
9. Pull out the clutch slider pins
PVT SYSTEM
5
in the inner sheave.
a s
and sliders .
5.25