Polaris Sportsman 850 Service Manual page 116

ENGINE / COOLING SYSTEM
17. Remove the push rivets retaining the right-hand
portion of the rear cab to gain access to the bolts
retaining the upper right-hand frame support.
i
18. Remove the bolts
support to allow engine removal.
19. Disconnect the CPS and stator wire harnesses.
20. Depressurize the fuel system at the fuel Schrader
valve. Disconnect the fuel line fitting from the fuel rail
and remove the fuel tank (see Chapter 3 "Fuel Pump
/ Fuel Tank Removal").
21. Remove the (4) screws retaining the engine skid
plate and remove the plate from the vehicle.
22. Place a drain pan under the front portion of the
engine.
23. Loosen the hose clamp and remove the coolant inlet
o
hose rom the water pump housing.
24. Slowly drain the coolant into the drain pan. Dispose
of used coolant properly.
25. The following steps may require you to use an
appropriate tool such as a pry bar to support the
engine.
3.44
and upper right-hand frame
a
26. Remove all bolts
engine to the transmission.
27. Remove the top bolt
mount.
rom both sides retaining the
s
rom the RH engine isolator