Interface Setup - Fujitsu DL3100 User Manual

FUJITSU DL3100
INTERFACE
SETUP

Interface setup

PnP No, Yes
No, Yes
USB ID
*The following options can only be set when carrying the RS232C Interface
Interface setup
Interface Share,USB,Serial
Baud Rate 9600,19200,38400,
4800,2400,1200,
115200
8,7
Data Bit
None,Odd,Even
Parity Check
Stop Bit 1,2
Data Stream No,Hardware,
Xon/Xoff
5-10
Valid Settings
Valid Settings
Function
No: Disables plug and play for USB
Yes: Enables plug and play.
No: Disables USB ID.
Yes: Enables USB ID
Function
Share: Printer can detect the type of input
signal and activate the USB or RS232C serial
port automatically.
USB: The printer can only use USB port.
Serial: The printer can only use RS232C serial
port.
This parameter chooses the transmission rate
of RS232C serial interfaces.
8: The number of each bit is 8.
7: The number of each bit is 7.
None: Bidirectional transmission has no
odd-even check.
Odd: Bidirectional transmission uses Odd
parity.
Even: Bidirectional transmission uses Even
check.
1: Transmit data bytes use one stop bit.
2: Transmit data bytes use two stop bits.
No: RS232C serial port has no flow control
Hardware: RS232Cserial port flow control is
hardware.
Xon/Xoff: RS232Cserial port flow control is
software.
User's Manual