Fujitsu DL3100 User Manual page 144

FUJITSU DL3100
Set relative vertical print position
(vertical position) =
((mH × 256) + mL) × (defined unit) + (top-margin
position)
(nL = 2, nH = 0,0 ≤ mL ≤ 255, 0 ≤ mH ≤ 127)
Notes
• Set the defined unit using the ESC ( U command.
• The default defined unit for this command is 1/60 inch.
• The new position is measured in defined units from the
current position.
• Moving the print position below the bottom-margin
position produces the following results:
Continuous paper moves the vertical print position to
the top-margin position on the next page,single-sheet
paper Ejects the paper.
Advance print position
Advances the vertical print position n/180 inch
(0 ≤ n ≤ 255)
Notes
• ESC J does not affect the horizontal print position.
• Moving the print position below the bottom-margin
position produces the following results:
Continuous paper moves the vertical print position to
the top-margin position on the next page,single-sheet
paper Ejects the paper.
Reverse paper feed
Reverse feeds paper (moves the print position in the
negative direction) n/180 inch.
(0 ≤ n ≤ 255)
Notes
• Do not reverse-feed paper more than 1/2 inch; the
vertical print position may not be accurate otherwise.
C-4
Function Command
ESC ( v (nL)
(nH) (mL)
(mH)
ESC J (n)
ESC j (n)
User's Manual